Connect Systems Inc. - Model 9800 Page 21
5.3. Remote Programming Enable
0 = Disable
1 = Enable
DEFAULT: 1 = Enable
5.4. Remote Programming Access Code (See page 29)
x - xxxx = Multi Digit Access Code
DEFAULT: 2345
******************** 9800-EXP ONLY ------------------->
The EXP version has two user programmable lines 5.5. and 5.9. which
allow customizing the 9800 for local phone conditions:
5.5. Ability to Dial a Second Dialtone
1 = Enabled
0 = Disabled
DEFAULT: 1 = Enabled
When enabled, dialing a second dialtone is possible. The
procedure used is different depending upon whether pulse or tone
dialing (1.8.) is selected. See "MANUAL DIALING WHEN SECOND
DIALTONE IS REQUIRED" page 31 for further details about dialing
second dialtones.
IMPORTANT NOTE: The following programming lines must not be altered
from the values shown: 5.6. = 6
5.7. = 33
5.8. = 24
If programming branches to one of these lines you may exit program
mode by turning the power off and then back on, or hold down the 'C'
key until you see A.A. You can go to any desired line number directly
from A.A. Simply enter the desired line number and press 'P'. Or,
repetitively tap the 'P' key until the desired line number is reached.
5.9. Call Progress, Tone Fill
Select 5 - 90 (10 - 180 Milliseconds)
2 Millisecond increments per step
Or, Select 91-99 (200-1000 Milliseconds)
100 Millisecond per step (91 = 200 mS, 92 = 300 mS, etc.)
DEFAULT: 10 = 20 Milliseconds
This parameter should normally not be changed. However if local
busy signal or dialtones have short gaps the Tone Fill parameter
can be used to fill them in. If either dialtone or
busy signal disconnect fail to operate, increasing the Tone Fill
time may be indicated. Do not add more fill than is needed to
restore proper operation.
<------------------- 9800-EXP ONLY ********************
Note: If you are attempting to use this Ver 3.0 manual to program an
earlier version, lines 0.1. - 4.2. are unchanged. To program lines
4.3. and up it is essential to obtain the correct manual. Or, upgrade
your older unit to version 3.0. Call CSI for details.
