Connect Systems Inc. - Model 9800 Page 24
Programming *, Pause or #
The No. 1, 2 and 3 keys on the keypad are used as dual input keys.
To program a phone number which contains any of these digits,
briefly press the key and continue with the number, as you would
with any other digit. To program a *, press the No. 1 key until a
single bar '| ' is added to the display (approx. 3 seconds) then
release the key. To program a pause, press the No. 2 key until a
dash ' -' is added to the display. To program a #, hold down the
No. 3 key until a double bar '||' is added to the display.
Note: A single bar '| ' will look like the digit one ' |',
except that the single bar is shifted to the left a little.
Note: The setting of line 5.5. determines whether the * means to
dial a * or wait for a second dialtone.
Phone Number Length Checking
A maximum of 16 digits may be entered in any speed dial location.
If too many digits are entered, the display will revert back to
showing the current location number. At this point, re-enter a
shorter phone number.
Returning to A.A.
If desired, you can return to a previously programmed speed-
dial memory by holding down 'C' for several seconds until A.A.
shows on the display. Now enter the speed dial line number you wish
to return to and press 'P'.
Returning to Operate
To return to normal operation, switch off the power and then back
on. You can now use your newly programmed speed dial numbers!
