Connect Systems Inc. - Model 9800 Page 19
3.9. Telephone Remote Base
0 = Disable [4.0.] Note: Must be set
1 = Automatic on Auto-answer [4.2.] to 0 for selective
2 = Access Code Required [4.2.] call operation.
DEFAULT: 0 = Disable
Enter 0 if remote base operation is not desired or if selective
calling is to be used. Enter 1 if remote base operation should
automatically occur after auto answer. Enter 2 if the access code
selected on line 1.4. should be required from the initiating
phone after the auto-answer beep.
Note: Only a DTMF telephone can perform a positive
disconnect by sending # in choice 1. Otherwise disconnect will
occur from activity or timeout timer timeout.
Note: Choice 2 will only function from DTMF telephones.
4.0. Selective Calling or Talk-Back Paging
1 = Selective Call Mode [4.2.]
0 = Talk back Page Mode [4.1.]
DEFAULT: 1 = Selective Call Mode
If talk back paging is selected the 9800 will only deliver a
one_way voice message to a pager.
4.1. Talk Back Time
Select 1-9 (3-27 seconds)
DEFAULT: 8 = 24 secs
Sets the talk time for talk back paging. Talk time is equal to
three seconds times the number entered.
Note: If CTCSS is used as a talk-back paging tone, resistor R8
must be removed. Simply lift one end.
4.2. Mobile to Mobile Signaling Note: DTMF signaling does not
1 = Enable generate alerting beeps.
0 = Disable
DEFAULT: 0 = Disable
When enabled, the 9800 can convert a mobile initiated DTMF
sequence into any of the optional tone formats. For example: DTMF
to Two Tone signaling. Mobile to mobile signaling is only
functional if a signaling option is installed. See page 37 for
details.
4.3. Signaling Mode (Signaling option is required)
0 = DTMF Signaling [5.3.]
1 = CTCSS Signaling [4.4.]
2 = Two Tone Signaling [4.5.]
3 = Five Six Tone Signaling [4.6.]
DEFAULT: 0 = DTMF Signaling
