Connect Systems Inc. - Model 9800 Page 23
_______________________________________________________________
| |
| TABLE 1 CW ID CHARACTER CODES |
|_______________________________________________________________|
| A = 0 | G = 6 | M = 12 | S = 18 | Y = 24 | 5 = 30 | WORD |
| B = 1 | H = 7 | N = 13 | T = 19 | Z = 25 | 6 = 31 | SPACE= 36|
| C = 2 | I = 8 | O = 14 | U = 20 | 1 = 26 | 7 = 32 | |
| D = 3 | J = 9 | P = 15 | V = 21 | 2 = 27 | 8 = 33 | SLANT |
| E = 4 | K = 10 | Q = 16 | W = 22 | 3 = 28 | 9 = 34 | BAR = 37 |
| F = 5 | L = 11 | R = 17 | X = 23 | 4 = 29 | 0 = 35 | |
| | | | | | | MESSAGE |
| | | | | | | STOP= 38 |
|_______|________|________|________|________|________|__________|
| |
| e.g. CW ID message desired is 'CSI' Enter 2, 18, 8, 38 |
|_______________________________________________________________|
-----------------------------------------------------------------
SPEED DIAL PHONE NUMBER PROGRAMMING
(Programming Area No.3)
To enter the speed dial phone number programming mode, press and hold
button No. 3 on the internal keypad and then simultaneously turn on
the power switch. At this point, the display will read 0.3. When you
release the No. 3 button, you will see A.A.
A.A. (GOTO Any Address)
Press 'P' to start at speed dial location 0.1., or enter
the speed dial location you wish to go to and then press 'P'.
Viewing or Changing Phone Numbers
A quick tap on 'C' will reveal the phone number stored at the
displayed line number. The phone number is displayed digit by digit
until all digits in the number have been shown. If the phone number
is acceptable, press 'P' to advance to the next line number or,
enter a new phone number and press 'P' to advance to the next line
number. The phone number stored at any line number can be erased by
entering three zeros. (000P).
Note: If there is no phone number stored at the present line
number, pressing 'C' will flash the current line number number once
instead of showing a phone number.
