
60203_revB Page 11 of 35
TURBO WATER LINE INSTALLATION
1. Locate the two heater hoses where they attach to the thermostat housing on the passenger side of
the engine. Cut as shown.
2. Install the 5/8” Tee (P/N 21651) into the rear hose. Install the ¾” Tee (P/N 21652) into the forward
hose. Secure using the supplied hose clamps (PN 30817).
TURBO OIL DRAIN INSTALLATION
1. Drill an 1/8” hole in the oil pan approximately 2.5” up from the bottom as shown. Enlarge the hole to
9/16” using a drill packed with grease to absorb the metal chips.
2. Liberally grease the included tap (30809). Use it to tap the hole in the oil pan. The tap is tapered so
check the hole with the included 3/8 NPT fitting before using more than half the threads on tap.
Warning: Threading the tap all the way in will result in a hole that is too large and leaks oil!
3. Using thread sealant, coat the threads of the 3/8 NPT fitting and install it into the oil pan.
4. Drain the rest of the oil from the engine.
5. Thread the ½” NPT x ½” barb oil drain fitting (31286) into the supplied 45º oil drain flange (21956)
with thread sealant. Install the oil drain flange onto the turbo using the supplied gasket so that the fitting
points towards the turbine housing.
6. Cut the supplied 1/2” hose (31290) to a length of 22”. Slide it over the oil drain fitting on turbo and
secure with pinch clamp (31287).