ENGINE DOGHOUSE
The engine doghouse inside the cab will be padded with a layer of sound and heat absorbing foam
and covered with heavy duty vinyl trim upholstery to match or accent the interior of the cab.
The underside of the engine enclosure shall be covered with a sandwiched material for interior cab
noise and heat rejection. The insulation for protection from heat and sound shall keep the dBa
level within the limits stated in the current edition of NFPA 1901.
ACCESS FOR FLUID SERVICING
The engine enclosure shall have a hinged and latched panel to provide access to the engine
lubricating oil dipstick, power steering fluid reservoir dipstick and engine coolant recovery
reservoir. This access shall allow that these fluid levels can be checked and topped off, if required,
without raising the cab.
CAB DOORS - INTERIOR TRIM
To provided durability the interior of the cab doors shall be finished with full length aluminum
panel that is finished with Zolatone high abuse paint.
INTERIOR CEILING PADDING AND TRIM
The cab front interior ceiling shall have a one-piece, removable, vinyl headliner to cover all wiring
and tubing used for lights and antenna leads.
INSIDE REAR WALL DIAMOND PLATE
Aluminum diamond plate shall be installed on the entire inside cab rear wall of a four side door tilt
cab.
FLOOR COVERING
The front and rear floor areas of the cab shall be covered with "HUSHCLOTH" sound barrier floor
mats. This floor mat shall be a three ply material with a 3/16" thick open cell isolation barrier of
Polyurethane, a 3/32" thick closed cell Nitrile mid barrier for section reinforcement, and a 1/16"
thick embedded pebbled grain wear surface.
REFLECTIVE MATERIAL - INTERIOR CAB DOOR
The cab and crew compartment doors shall have a minimum of 96 square inches of white reflective
material affixed to the inside of each door. There shall be a 2" red chevron stripe applied over the
white reflective material on each door.
LED WARNING LIGHTS - CAB DOOR FOSTER LIGHT
The interior of each door shall include one 16 inch long X 3/4 inch tall amber Weldon LED
warning light. The light shall be mounted on the inside of the door above the door window to the
extreme outboard edge of the door so it is visible from the rear of the vehicle. As a traffic warning
indicator the light shall activate with a scrolling directional flash pattern which moves from the
door hinge area outward when the door when it is in the open position.
INTERIOR CAB STEP TRIM
The cab steps shall be completely enclosed behind each door. The top surface of the steps shall be
covered with non-skid aluminum tread plate trim.
