BATTERY BOX TRAY - STAINLESS STEEL
The battery box trays shall be stainless steel to reduce the corrosive potential of the tray. The
battery hold down and brackets and hardware shall also be made of stainless steel.
There shall be black Dri-Dek matting installed beneath the truck batteries.
BATTERY BANK
A single battery system shall be provided, utilizing four (4) high cycle type Group 31 batteries.
This system shall be capable of engine start after sustaining a continuous 150 amp load for 10
minutes with the engine off.
A battery disconnect switch Rated at not less than 450 amps continuous shall be used to activate
the system and provide power to the power panel. A green pilot light shall illuminate to indicate
that the battery bank is activated.
BATTERY CABLES
All battery wiring shall be "GXL" battery cable capable of handling 125% of the actual load. It
shall be run through a heat resistant flexible nylon loom rated at a minimum of 300 degrees
Fahrenheit. All cable connections shall be machine crimped and soldered.
STARTING CIRCUIT
One (1) engine start button is to be located on the lower right dash panel. It shall be wired to heavy
duty solenoid rated at not less than 1100 amps. The battery indicator light is to be located directly
above the start button to indicate that the battery bank is on.
BATTERY CHARGER
A Pro/ Mariner on board solutions model 1240, advanced electronic 4-step battery charger/power
supply with a 40 amp output shall be installed, under the driver's seat.
REMOTE CHARGE INDICATOR PANEL
A KUSSMAUL 91-94-12 charge indicator shall be supplied. The remote charge indicator shall be
located on the driver's seat box adjacent to the master battery switch.
SHORELINE AUTO-EJECT
A KUSSMAUL Super Auto Eject, model 091-55-20-120, with weatherproof cover shall be
provided.
The Super Auto Eject is to be completely sealed to prevent internal contamination of the working
components.
The Auto-Eject cover shall be a Kussmaul 091-55YW, yellow in color and mounted on the exterior
of the cab behind the driver's door.
BATTERY JUMPER STUDS
Battery jumper studs shall be provided on the chassis. The jumper studs shall be mounted
underneath the cab, on the rear of the driver's side battery box. The studs shall be connected to the
chassis batteries with 1/0 color coded cables, red for the positive cable and black for the negative
cable. The studs shall be protected with color coded plastic covers when not being used.
