shall have exterior and interior paddle type latches for ease of opening with a gloved hand. The
paddle latches are to have a rubber gasket, on the outside, separating the handle from the finished
painted surface.
FRONT DOORS
The cab front doors shall be of the full-length design enclosing the entire step area of the cab. The
door shall be a minimum of 38-1/2 inches wide and 74 inches tall. The front door windows shall
have a minimum of 712 square inch area of viewing glass per door. There shall be a fixed piece of
forward glass in each of the front doors.
REAR CAB DOORS
The rear cab doors shall be similar to the forward doors and shall be located directly behind the
front wheel well area. These doors shall be 86 inches high x 34 inches wide. Each door shall have
a roll down rear window with a minimum glass viewing area of 670 square inches.
INTERIOR DOOR LOCKS
All doors shall have door locks with interior controls and exterior keyed door locks. Each door
shall be equipped with a locking mechanism with an operating means in the interior of the vehicle.
The doors shall be equipped with appropriate safety interlocks to prevent accidental locking of the
doors when closed.
DASH TRIM
The drivers cab dash console shall be made of black ABS with an appearance of the latest in
automotive design, styling. Accompanying the dash console in the forward section of the cab shall
be an officer’s side flat dash for the mounting of a mobile data terminal.
CAB GLASS
AS-1 safety laminate glass shall be used in a two piece, wrap around design with a minimum 3760
square inches of windshield area for maximum visibility. The windshield shall have the style of a
one-piece assembly with the practical installation of two pieces for lower replacement cost. The
windshield shall be readily available from a nationally recognized automotive glass manufacturer
that maintains local distribution outlets.
All glass shall be tinted. All fixed glass shall be installed with a one-piece triple locked rubber
lacing material. Due to long term appearance two-piece chrome trim lock lacing is not desired.
SUNVISORS
The driver and officer side of the cab shall be equipped with a sun visors. The vinyl covered visors
shall be a minimum of 17-1/2" by 9".
DRIVER SIDE ELECTRICAL CABINET
Beneath the driver’s seat there shall be an electrical cabinet designed to house the main battery
electrical disconnect and facilitate the installation of an onboard battery charger or battery
conditioner. A bolt on limited access; aluminum diamond plate hatch shall be installed on the front
side of the seat box. The access hatch shall have a louvered section to provide air circulation to the
cabinet.
