SCION xB 2004 - BASS TUBE (BAZOOKA
®
)
Procedure
Page 8 of 15 pages
Issue: A 08/16/04
(a) If vehicle is equipped with a rear cargo mat
(PN:PT206-52043-02), the mat must be
removed prior to drilling the rear cargo
panel.
(1) The cargo mat must be placed onto a
safe, & stable surface, where punching is
safe.
(b) In order to prepare the rear cargo mat, the
cargo panels must be drilled (Step 8 (e))
(c) Once the cargo panel has been drilled place
the panel back into the vehicle (Step 8. (i));
place the paper (cargo mat) drill template on
top of the pre-drilled cargo panel. (Fig. 9-1)
(1) Ensure that the paper (cargo mat)
template sits within the same footprint as
the cargo area.
(2) Mark the four (4) drilled holes of the
cargo panel, onto the paper template.
(Fig. 9-2)
(d) Once marked, remove the paper template,
and place it over the cargo mat. Place the
5/16” Arch Punch over each marked spot,
and punch four (4) holes (through the paper
template & mat) using the rubber mallet.
(Fig. 9-3)
(e) Once the mat is punched, remove the panel
from vehicle, & revert back to Step 8 (f).
10. Reassemble Rear Seat
(a) Place rear seat back into vehicle, and “re-
loop” center safety loop onto bracket.
(b) Insert seat belt latches into their respective
slots and ensure that the center seat belt latch
is routed to its correct position. (Center latch
is identified with a “CENTER” marking)
STOP
STOP
Fig. 9-1
Fig. 9-2
Fig. 9-3
