SCION xB 2004 - BASS TUBE (BAZOOKA
®
)
Procedure
Page 7 of 15 pages
Issue: A 08/16/04
the top mounting plate, (through the pre-
punched cargo mat – if equipped), through
the cargo panel and into the threaded backing
plate, located underneath the panel. (Fig. 8-4)
(1) Position the “curled” side of the top
mounting plate as shown in Fig. 8-3.
(h) Securely tighten the four (4) M6 x 30mm
Bolts using the 10 mm socket.
(i) Place the rear cargo panels back into the
vehicle – do not lock panels at this time.
(j) Install the Bazooka Tube by aligning the
mounting brackets on the tube with the
mounting plates on the panel.
(1) The screen portion of the tube must be
facing the rear of the vehicle.
(k) Secure the Bazooka tube mounting brackets
to the mounting plates using the supplied
mounting bracket knobs. (Fig. 8-5)
(l) Connect the Bazooka to the Wire Harness by
plugging the 14-pin Molex Connector
(routed behind the rear drivers’ side seat) into
the back of the Bazooka.
(1) Confirm that the rotary knob (gain
control) on the back of the unit is set
completely counter-clockwise (until it
can not be turned any further) & that the
slide switch (phase) is in the up position.
(Fig. 8-6)
(m) Re-Lock the cargo panel back into vehicle.
9. Preparing Rear Cargo Mat (if equipped)
NOTE: Paper (cargo mat) drill templates are
included in every kit and are to be used to
modify the rear cargo mat when used with the
Bazooka Subwoofer.
Fig. 8-5
Fig. 8-6
