SCION xB 2004 - BASS TUBE (BAZOOKA
®
)
Preparation
Page 1 of 15 pages
Issue: A 08/16/04
Part Number: PTS20-52040
NOTE: Part number of this accessory may not be
the same as the part number shown.
Kit Contents
Item # Quantity Reqd. Description
1 1 Bazooka Tube Assembly
2 1 Wire Harness
3 1 Hardware Bag
4 4 Paper Drill Templates
5 1 Installation Instructions
6 1 Care Card
Hardware Bag Contents
Item # Quantity Reqd. Description
1 10 7” Wire Ties
2 10 4” Wire Ties
3 4 M6 X 30mm Bolts
4 2 M6 X 25mm Bolts
5 2 Threaded Backing Plates
6 2 Top Mounting Plates
7 2 Bracket Mounting Knobs
Additional Items Required For Installation
Item # Quantity Reqd. Description
1
Conflicts
None
Recommended Tools
Personal & Vehicle
Protection
Notes
Vehicle Protection Seat/Floor Covers
Part Protection Blankets
Special Tools Notes
Arch Punch (For use with
Rear Cargo Mat only)
5/16” Hole Diameter
(McMaster PN: 3427A12)
Mallet (For use with Rear
Cargo Mat only)
Rubber Mallet
Marker
Installation Tools Notes
Panel Removal Tool Nylon Removal Tool (NRT)
Socket/Ratchet 10mm & 12mm
Socket Extension 6 inch (optional)
Torque Wrench
3 lbf·ft , and 10 lbf·ft
Pliers 1. Diagonal Cutters
2. Long Nose (optional)
Screwdriver Magnetized Philips # 2
Electric Drill 5/16” Drill Bit
Utility Knife
Special Chemicals Notes
Cleaner 3M
TM
Prep Solvent–70 (if
required)
General Applicability
All SCION xB Grades
Recommended Sequence of Application
Item # Accessory
1 Install Security/Audio
2 Install Bazooka Tube
3 Install Door Sills
4 Install Molded Dash
*Mandatory
Vehicle Service Parts (may be required for reassembly)
Item # Quantity Reqd. Description
1
Legend
Bass Tube Specifications
Woofer Size 8”
Voice Coil Size
1”high power/high
temp.
Magnet Size 15 oz.
Frequency Response 39 – 85 hz.
Efficiency 105dB
Power Handling 100 watts
Dimensions 18.125” x 8.5” x 10”
Weight 14 lbs.
Impedance 2 ohms DVC
STOP: Damage to the vehicle may occur. Do not
proceed until process has been complied with.
OPERATOR SAFETY:
Use caution to avoid risk of
injury.
CAUTION:
A process that must be carefully observed
in order to reduce the risk of damage to the
accessory/vehicle and to ensure a quality installation.
TOOLS & EQUIPMENT:
Used in Figures calls out the
specific tools and equipment recommended for this
process.
REVISION MARK:
This mark highlights a change in
installation with respect to previous issue.
