SCION xB 2004 - BASS TUBE (BAZOOKA
®
)
Procedure
Page 5 of 15 pages
Issue: A 08/16/04
(g) The rear bench must be “de-looped” from
center safety loop and all seat belt latches
need to be pushed through their respective
slots. (Fig. 7-6 & 7-7)
(h) Route the wire harness underneath the rear
carpet as shown. (Fig. 7-8)
(i) Route the 14 Pin Molex connector,
underneath the rear seat pivot rod (under the
#2 passenger side clip, nearest the center),
and continue routing the wire harness to the
right. (Fig. 7-9)
(j) Using a 12mm socket, remove the center
Anchorage bolt located on the middle
mounting bracket and install the wire harness
ground ring underneath the bolt.
(1) Connect the ground ring to the hole just
prior to routing the wire harness through
the center pivot bracket. (Fig. 7-10)
(2) Torque bolt to 10 lbf·ft
(k) Collect any excess harness and wire-tie the
wire harness to the rear seat pivot rod using
three (3) 7” wire ties. (Fig. 7-11)
(1) Using the diagonal cutter pliers, clip the
three (3) 7” wire ties.
(l) Route the 14 pin Molex connector behind the
drivers’ side rear seat, into the rear cargo
area.
8. Mounting the Bazooka Tube
NOTE: Paper (cargo panel) drill templates are
included in every kit & are to be used for
customer/DIO installation. PPO (cargo panel)
drill templates have been supplied to the TLS
facilities.
STOP
Fig. 7-6
Fig. 7-7
Fig. 7-10
Fig. 7-11
Fig. 7-9
Fig. 7-8
