Dil ID: 8
Dil Adı: italy
Dil Kodu: it4tayfun Prodotti del Marchio Scion
Dünyanın En Büyük
Elektronik Bilgi Kütüphanesi



SCION xA 2004 − SECURITY WITH RKE (V3)
Section II − Installation Procedure
Page 7 of 23 pages Supplier Ref #: DIO
Issue: A 06/09/03
7. Disconnect the empty 1P female connector
plugged into the V3 harness’ 1P male
connector. (Fig. C−4)
8. Using a small flat blade screwdriver, lift up the
terminal retainer on the back of the empty 1P
connector. (Fig. C−4)
9. Insert the terminal at the end of the vehicle
harness’ RED wire into the empty 1P
connector. (Fig. C−5)
i. Verify the correct opening is chosen.
ii. Verify the terminal is inserted and seated
properly.
iii Close the retainer.
iv. Terminal should not come out when pulled
lightly from the back, if terminal comes
off, then push it in again.
10 Plug in the V3 harness’ white 1P male
connector into the V3 harness’ white 1P female
connector. (Fig. C−6)
i. Verify the connectors are plugged in
securely.
ii Refit the diode to the vehicle harness’ 3P
connector.
11. Plug in the V3 harness’ white 13P connectors
between the driver’s side cowl area and the
vehicle harness 13P connector. (Fig. C6)
i. Verify the connectors are plugged in
securely.
12. Plug in the V3 harness’ white 14P connectors
between the driver’s side cowl area and the
vehicle harness 14P connector. (Fig. C 6)
i. Verify the connectors are plugged in
securely.
STOP
STOP
Fig. C−4
Small Flat Blade Screwdriver
Retainer
1P (Female)
1P (Male)
V3 Harness
Fig. C−5
V3 Harness
RED Wire
3P (White)
1P (Male)
V3 Harness
Vehicle Harness
RED Wire
STOP
Retainer
1P
(Female)
Fig. C−6
3P (White)
Diode
13P (White)
1P (White)
14P (White)