SCION xA 2004 − SECURITY WITH RKE (V3)
Section II − Installation Procedure
Page 5 of 23 pages Supplier Ref #: DIO
Issue: A 06/09/03
B. Piezo Buzzer Installation
1. Using one large foam tape and one large wire
tie, secure the Piezo Buzzer to the vehicle’s
harness near the vehicle’s clip. (Fig. B−1)
i. Do not cover the opening of the Buzzer
with the foam tape.
ii. Ensure Buzzer opening is facing
downwards.
2. Locate the gray 2P connector near the vehicle
grommet. (Fig. B−2)
i. Remove and discard the cap from gray 2P
connector.
3. Plug in the Piezo Buzzer harness gray 2P
connector to the vehicle harness gray 2P
connector. (Fig. B−3)
i. Verify the connectors are plugged in
securely.
4. Using one large foam tape and one large wire
tie, secure the gray 2P connectors to the
vehicle harness. (Fig. B−3)
STOP
Fi
. B−1
STOP
Piezo Buzzer
Vehicle’s Clip
Large Foam
Tape
Large Wire Tie
Side Cutter
Fig. B−2
Piezo Buzzer
Cap
2P (Gray)
Fi
. B−3
Side Cutter
Piezo Buzzer
2P (Gray)
Large Wire Tie
Large Foam Tape
