SCION xA 2004 − SECURITY WITH RKE (V3)
Section II − Installation Procedure
Page 2 of 23 pages Supplier Ref #: DIO
Issue: A 06/09/03
Section II − Installation Procedure
NOTES:
Removed Parts:−
Place all removed parts on a protected surface.
Connectors:−
When disconnecting connectors, do not pull on the
wires; pull on the connectors.
Wire Ties:−
When using wire ties to secure harness, clip the
wire ties after securing them.
A. Vehicle Disassembly
1. For automatic equipped vehicles, place the
shifter in low gear and set the parking brake
prior to disconnecting the battery.
2. Remove the negative battery cable. (Fig. A−1)
i. Protect the fender before starting.
ii. Do not touch the positive terminal with
any tool when removing cable.
3. Using a Nylon Panel Removal Tool, remove
the driver’s side step cover. (Fig. A−2)
i. Cover the floor and seats before starting.
ii. Remove the float clip first to prevent
damaging the panel.
4. Remove the driver’s side cowl cover.
(Fig. A−3)
i. Remove the nut securing the cowl cover.
5. Remove the driver’s side fuse cover.
(Fig. A−4)
i. Remove and discard the knockout cover
third space from the left.
Fig. A−3
Cowl Cover
Nut
STOP
STOP
STOP
STOP
STOP
Fig. A−2
Panel Removal Tool
Step Cover
Float Clip
Fig. A−4
Fuse Cover
Knockout Cover
Fig. A−1
Socket (10 mm), Ratchet
Negative
Battery
Cable
