SCION xA 2004 − SECURITY WITH RKE (V3)
Section II − Installation Procedure
Page 18 of 23 pages Supplier Ref #: DIO
Issue: A 06/09/03
H. Completing the Installation
1. Complete the reassembly of the vehicle.
i. Reconnect any disconnected connectors.
ii. Verify the panels fit together properly with
no uneven gaps between them.
2. Clean up and remove any trash.
3. Reconnect the vehicle’s negative battery cable.
(Fig. H−1)
i. Position the negative terminal to the
battery as shown (~45 deg.).
ii. Tighten the nut to 4.1 N−m (36 lbf−in).
iii. Do not touch the positive terminal with
any tool when replacing the cable.
4. Place the owner’s manual and warranty card
(left in their protective bags), in the glove box.
5. After completing the Functional Checks
(Section III) place the remote transmitters (left
in their protective bags), in the glove box.
Socke
(10 mm)
Torque Wrench
Fig. H−1
45 deg.
Negative
Battery Cable
