SCION xA 2004 − SECURITY WITH RKE (V3)
Section II − Installation Procedure
Page 17 of 23 pages Supplier Ref #: DIO
Issue: A 06/09/03
7. Mount the V3 ECU to the glove box area with
the vehicle’s bolt. (Fig. F−6)
i. Verify the bolt is tightened securely.
ii Verify the V3 harness does not droop
downward.
8. Using a small strip of foam tape, secure the
GRAY Antenna wire to the inside surface of
the upper dash cover as shown. (Fig. F−7)
G. Warning Label Installation
1. Using 3M
TM
Prep Solvent−70 (or Household
Windex), clean the inside surface of the front
door windows in the area where label will be
affixed.
i. When cleaning with 3M
TM
Prep
Solvent−70 follow the manufacturer s
directions. Do not allow cleaner to air dry.
2. Place warning label on the inside surface of
the front door windows as shown. (Fig. G−1)
i. Use a piece of clear adhesive tape to lift
the labels off of their protective backing
sheet.
ii. Do not touch the adhesive surface of the
warning labels.
iii. Line up the labels properly and place them
on the glass once; do not use a label that
was pulled off the glass.
STOP
STOP
Fig. F−6
10mm Socket
Vehicle’s Bolt
V3 ECU
V3 Harness
V3 ECU
Small Foam Tape
Antenna wire
(GRAY)
Fig. F−7
Fig. G−1
Warning
Label
10 mm
Lineup with
Bottom of
Window Etching
