Connect Systems Inc. - Model 9800 Page 25
TOLL OVERRIDE PROGRAMMING
(Programming Area No. 4)
To enter the TOLL OVERRIDE programming area, press and hold button No.
4 on the internal keypad and then simultaneously turn on the power
switch. At this point, the display will read 0.4. When you release the
No. 4 button, you will see A.A.
A.A. (GOTO Any Address)
Press 'P' to begin entering TOLL OVERRIDE selections into memory
line 0.1., or enter the TOLL OVERRIDE line number you wish to go to
and then press 'P'.
Viewing or changing TOLL OVERRIDE codes
A quick tap on 'C' will reveal the user programmed TOLL OVERRIDE
code at the current line number. The TOLL OVERRIDE code is
displayed digit by digit until all digits in the code have been
shown. If the TOLL OVERRIDE code is acceptable, press 'P' to
advance to the next programming line and enter the next override
code etc. Any memory line number can be erased by entering three
zeros followed by P (000P).
Note: If there is no TOLL OVERRIDE code programmed at the current
line number, pressing 'C' will flash the current line number once
instead of showing a programmed TOLL OVERRIDE code.
Programming a Wildcard (*)
The No. 1, key on the keypad is used as a dual input key. A brief
press enters a 1. If the 1 button is held down for three or more
seconds it becomes a * entry. The display will show '| ' which
indicates a * has been entered.
Note: A single bar '| ' will look like the digit one ' 1',
except that the single bar is shifted to the left a little.
Returning to A.A.
If desired, you can return to a previously programmed TOLL
OVERRIDE location by holding down 'C' for several seconds until
A.A. shows on the display. Now enter the TOLL OVERRIDE line number
you wish to return to and press 'P'.
Returning to Operate
To return to normal operation, switch off the power and then back
on. Your newly programmed TOLL OVERRIDE codes are now active.
