14
1. This function is applicable for 1080p input signal only.
2. When the Pacific C-A / C-AG (SDI OUT) is connected to the Pacific C-SHS (SDI IN), make sure that the
Pacific C-A / C-AG’s COLOR CORRECT function is enabled (set On) and the Pacific C-SHS’s COLOR
CORRECT function is disabled (set Off) to allow the embedded color corrected signal to pass through.
On: This feature in the Pacific C-AG synchronizes the video sources
(Signals from DVI-I IN, SDI/CVBS IN, and HDMI IN ports will be
synchronized with the Ref IN port signal).
GENLOCK OUTPUT: refer to table 2-11 for more details on
supported output standard.
TIMING OFFSET: sets the delay lines.
for SD 525 signal up to 524 delay lines
for SD 625 signal up to 624 delay lines
for 720p signal up to 749 delay lines
for 1080p or 1080i or 2048p signal up to 1124 delay lines
Off: disables the genlock feature.
Exits the genlock setup menu.
Table 2-10 Genlock
1. For models (Pacific C-A) without the genlock feature, this item is not available for configuration.
2. Genlock feature is not available when “OUTPUT PORT”
”STANDARD” is set to “VESA.”
3. The genlock feature requires a sync reference signal entering the Ref IN port. Changing or
disconnecting the sync reference will cause the Pacific to automatically turn off genlock.
Table 2-11 Genlock Output
