2.3.8 Standby

When the standby function is activated, the display dims after 10 minutes, to

reduce energy consumption.

If the option not during a running program is selected, the standby function only

acts before and after a program cycle, not during a running program.

2.3.9 Water intake

Activation of hot water valve (Y12 / 2Y40).

Customization of the water intake control and the laundry process.

2.3.10 Max. water level

Adjustment of the laundry process for soft water areas.

Level III at rinse cycle.

2.3.11 Country version

Adjustment of the laundry process depending on the country of destination.

2.3.12 Max. spin speed

Adjustment of the final spin speed.

2.3.13 Load automatic

For detergent test facilities only.

Activate / deactivate intelligent water intake (IWE).

2.3.14 Imbalance values

Adjustment of the imbalance thresholds.

2.3.15 Central unit

Function data not available at this time.

2.3.16 Heater output

The heater output influences the wash cycle time/residual time indication.

2.3.17 Low water pressure

If the flow pressure is lower than 1 bar, the water intake monitor – water control

system (WCS) registers this as a fault, refer to 040 2.4 Water intake monitoring –

water control system (WCS).

Descriptive Technical Documentation

DTD no. 11-4800 070-5