TD 92675EN
20 June 2012 / Ver. E
Configuration Manual
Ascom i62 VoWiFi Handset
27
5. Maintenance
3 In the Number menu, select “Rename...“. Alternatively, right-click the handset and
select “Rename...” from the menu that appears.
4 In the New prefix field, enter the new prefix (if needed).
5 In the New number field, enter the new number.
NOTE: Make sure that the new number does not ex
i
st in another system. If several handsets
have the same number, their settings will overwrite each other when synchronizing
with IMS3/PDM.
6Click “OK“.
The new number will be synchronized with the handset when it is
connected to PDM or
IMS3.
5.4 Update Parameters via IMS3
This section describes the general procedure on how to change/update parameters using
the IMS3. The update starts when the handset is idle and will not interrupt an ongoing call.
NOTE: Only select the parameters that are changed, if all parameters are sele
cted, the
system performance decreases.
1Open the IMS3.
2 Create a new template with only the parameters that shall be changed.
3 Select the numbers that should be updated and apply the t
emplate.
The ha
ndsets are automatically updated from the IMS3 and might be restarted
depending of which param
eters that are changed.
5.5 Perform a Security Upgrade via IMS3
This section describes how to perform an update/change of the WLAN password/
authentication using the IMS3.
IMPORTANT: Change settings in the handset before change
settings in the AP. Else,
synchronization of new settings to the handset settings cannot be performed.
Tip: Leave one access point with the old configu
ration to allow switched off handsets to
receive the updates when they are turned on. Bring the handset to that APs coverage area.
1Open the IMS3.
2 Create a new template with the new security settings.
•Security mode
1
3 Apply the new template to the handsets.
The handsets are automatically updated from the IMS3 and restarted.
NOTE: At this time, the handsets have no access to the WLAN system.
4 Change the security settings for the access points.
The handsets are now able to access the WLAN.
1. All required settings for the WLAN. For example User name, Password, Regulatory domain etc.
