60203_revB Page 29 of 35
2. Do not remove the white pad from the air filter housing. Place the factory air filter onto the housing
and secure by snapping on the supplied clamp as shown.
3. Install the 4” silicone elbow onto the air filter housing. (Lightly grease the elbow to aid installation.)
Attach the open end of the elbow to the compressor inlet. Orient for best fit and secure with #64 clamps.
4. Use the supplied 1.5” tube to attach the bypass valve discharge to the air inlet elbow using the
supplied 1.5” 45º elbow.
5. Unplug the evap. purge solenoid (located on the front of the passenger side head) electrical
connector and hose and move out of the way. Secure the heater hoses out of the way.
6. Disconnect the PCV hose from the intake manifold. Use a 1/4” drill bit to slightly enlarge the inside
diameter of the plastic tube by hand turning the bit.
