60203_revB Page 26 of 35
2. Thread the supplied 1/8” npt to 5/32 hose fitting into the hole in the bottom of the intercooler. Thread
a vibration dampener into long boss on bottom of intercooler and an M8 x 25mm stud into the short boss.
3. Install the bypass valve o-ring onto flange. Loosely attach the bypass valve to the intercooler. Test fit
intercooler, clock bypass valve, and then tighten the set screws as shown.
4. Install the short end of the 2 ½” 45º compressor discharge sleeve onto the intercooler inlet.
5. Install the intercooler by sliding the inlet sleeve between the radiator and the core support and onto
the compressor discharge elbow. Align the lower mounting studs with the lower core support slots. Mount
the top of the intercooler to the vibration dampeners using M8 nuts and lock washers.
