60203_revB Page 31 of 35
10. Remove the vacuum hose from the brake booster reservoir. Using sealant, install the 1/16 npt to
3/16” barb fitting into the ½” barb x ½” barb x 1/16” female npt tee fitting. Clamp a 2” section of ½” hose
to the tee using the supplied pinch clamp. Attach the tee to the factory vacuum hose using the original
clamp. Attach the ½” hose to the brake booster reservoir and secure with pinch clamp.
11. Run 5/32” hose from the tee to the hose barb on the bypass valve. Secure away from the exhaust.
RE-ASSEMBLY
1. Cut the stud off of the rear of the driver side headlight assembly where it would interfere with the inlet
sleeve. Install the headlight.
(Note: The headlight may still be adjusted after the stud is cut but range will be limited. If large changes
in headlight adjustment are foreseen, leave stud as is and protect with a vacuum cap until after headlights
are adjusted).
2. Install the front bumper and cover.
3. Install the engine cover.
4. Re-attach the rear valance body panel.
CLEAN UP
1. Review these instructions to make sure that all fasteners, clamps & electrical connections have been
installed and torqued correctly.
