60203_revB Page 17 of 35
9. Connect the oil drain line to the fitting previously installed in the oil pan and secure with a pinch
clamp.
10. Using a banjo bolt (31155) and two crush washers (31156) connect the remaining braided water line
to the back of the turbo center housing. Route both water lines down and across to the previously
installed Tees in the coolant lines.
11. Thread the supplied 1/8 NPT x -4 90º fitting into the oil feed on the turbo. Slip heat sleeve over the oil
feed line and attach the line to the turbo.
TURBO EXHAUST INSTALLATION
1. Bend the forward transmission cooler lines (below a/c compressor pulley) down as far as possible.
2. Slide heat shield over the A/C clutch harness.
3. Bend the lower transmission cooler lines towards the transmission.
4. Using a pry bar, bend the A/C tubes against the A/C compressor.
