60203_revB Page 15 of 35
TURBOCHARGER INSTALLATION
1. Loosely attach the cat to turbo #3 bracket (22141) to the cat to turbo #3 pipe (22127) flange using two
M10-1.25x40mm bolts and flat washers as shown. Install the two M10-1.25x42mm studs into the
remaining two holes in the turbo flange. Use the supplied exhaust wrap to insulate the pipe and secure
with the supplied exhaust ties
2. Remove the nut from the alternator bracket and attach the cat to turbo #3 bracket using the factory
nut.
3. Remove the bolt from the engine behind the alternator (has small ground wire) and attach cat to turbo
#2-3 bracket (22140) using the factory bolt in the lower location and the supplied M10 x 50mm bolt, lock
washer and .8” spacer. Loosely install a 2.5” clamp over the pipe and the bracket.
4. Place the cat to turbo #2 pipe (22126) into the space between the driver side exhaust manifold and
the steering shaft and insert it into the open end of cat to turbo #3 pipe.
Supplied
bolt, bracket
and s
ace
Remove and
replace nut
Factory
bolt
M10-1.25 x
42 Studs
M10-1.25 x
40 Bolts &
Flat
a
h
r
.8” s
ace
