60203_revB Page 16 of 35
5. Attach cat to turbo #2 bracket (22139) to the boss on the engine block behind the exhaust manifold
with the supplied M10-1.5 x 30mm bolt and lock washer. Loosely install a 2.5” clamp over the bracket.
6. Loosely re-install the driver side cat.
7. Using a banjo bolt (31155) and two crush washers (31156) connect one of the supplied braided water
lines to the front of the turbo center housing. (There is better access at this time than after the turbo is
installed.)
8. Place the supplied gasket onto the turbo mounting flange. Mount the turbo (guiding oil drain line
under alternator) using four M10-1.25 nuts and lock washers.
To Turbo
Installed water line
Heat wrap
this section
