FIGURE 15
35. Relocate M-BEC up into the IP to gain access to
Front-of-Dash Matte Opening behind M-BEC.
36. Locate cut-out in dash matte. Locate the dimple in
the sheet metal and then use a center punch to help
start a drill bit as close as possible to dimple. Using
a power drill and a 25.4mm (1”) hole saw, drill out
the chassis harness pass-through (2). Figure 16.
FIGURE 16
37. If this location is occupied by Trailer Brakes (&JL1)
or another Accessory, drill a new Chassis Harness
pass-through (3) between the IP Harness (1) and
Trailer Brake (2) pass-through grommets. Figure 16.
38. Clean rough edges using a Deburring Tool. Figure
16.
39. Apply Anti-Corrosion Coating to the opening. Figure
16.
Install NAV Harness
40. Remove the NAV radio trim bezel by inserting plastic
trim removal tool along edges and twisting retaining
clips. Figure 17.
FIGURE 17
41. Remove fasteners retaining accessory and HVAC
control head using 7mm socket. Figure 18.
FIGURE 18
42. Remove fasteners retaining radio control head using
a 7mm socket. Once fasteners are removed, lower
the radio and unplug brown connector. Figures 19
and 20.
