FIGURE 10
23. Snap the Tailgate Bezel Assembly into the Tailgate.
24. Seat the second grommet (4) securely around
opening. Figure 10.
25. Install remaining Tailgate Latch Handle Bolt in
Tailgate and tighten all three 13mm bolts to 25 N·m
(18 lb ft).
26. If present, remove the Rear License Plate.
27. With the help of an Assistant, re-install the Tailgate
onto the Pickup Box, carefully routing the Camera
harness through the opening on the Pickup Box Sill.
28. Re-attach Tailgate Support Cables and close
Tailgate. Figure 11.
FIGURE 11
29. Through the License Plate Opening pull the Camera
Assembly Harness (2) until the first grommet (3) is
properly seated in the Pickup Box Sill (1). Figure 12.
FIGURE 12
Cut Accessory Pass-Through in Front of
Dash
30. Using a Trim Removal Tool, remove Left Instrument
Panel Outer Trim Cover (1). Figure 13.
FIGURE 13
31. Remove the Parking Brake Release Handle Bolt and
then the Handle. Remove the two Knee Bolster
Assembly Screws (1) and the Knee Bolster Assembly
(2). Figure 14.
FIGURE 14
32. Disconnect the electrical connections, if applicable.
33. Remove the M-BEC cover.
34. Disengage the M-BEC (1) from support bracket.
Figure 15.
