FIGURE 35
64. Install the MBEC cover onto the MBEC.
65. Raise vehicle on hoist to route the Chassis Harness.
66. Route the supplied Chassis Harness, working
towards the rear of the vehicle, along the existing
Chassis Harness, routing away from Body Mounts.
67. Connect the supplied Chassis Harness to the Camera
Assembly Harness.
68. Secure the supplied Chassis Harness along the
existing Chassis Harness using Wire Ties every
200mm (approximately 8”). Note: Depending on the
vehicle wheelbase there may be excess length in the
Chassis Harness. Loop, and secure with supplied
Wire Ties any excess harness length along the Body
Frame away from Mechanical areas.
69. Lower the truck.
70. Re-Install Rear License Plate, if necessary.
71. Connect the negative battery terminal. Tighten the
negative cable nut to 5 N·m (44 lb in).
72. System requires a GM dealer or authorized installer,
using a tech 2, to reprogram the NAV radio to
accept video display (reference GM part number
25836479).
73. Test system functionality.
74. Re-install the Knee Bolster Assembly. Tighten
Screws to 2 N·m (18 lb in). Re-install Parking Brake
Release Handle and Bolt, tighten to 9 N·m (80 lb in).
Figure 37.
FIGURE 37
75. Re-install Instrument Panel Outer Trim Cover. See
Figure 13.
