Продукция бренда Buick

2. Remove tie wraps and wire harness strap securing ignition switch harness. Remove mounting screws.

Remove ignition switch assembly. To install, reverse removal procedure. Tighten mounting screws to 12

INCH lbs. (1.4 N.m)

LOCK CYLINDER

Removal & Installation

1. Remove upper and lower cover. See UPPER & LOWER COVER . On floor shift models, remove pivot

and pulse switch for access to pass key wiring. See PIVOT & PULSE SWITCH . On all models, turn

lock cylinder to RUN position. Press locking button on back of bearing and housing assembly. Remove

lock cylinder and lock preload spring.

Disconnect steering column electrical connector. Remove Gray turn signal switch connector from column

connector. Remove 17-

way secondary lock and disconnect pass key terminals (if equipped), from cavities

16 and 17. See Fig. 2

. Remove tie wraps and wire harness strap. Remove wiring guard and lock cylinder.

To install, ensure sector is in RUN position. With key in lock cylinder, align locking tab with housing and

press into position. Install lock preload spring. To complete installation, reverse removal procedure.

Fig. 2: Removing Pass Key Wire Terminals

Courtesy of GENERAL MOTORS CORP.

PARK LOCK CABLE

NOTE: Ensure lock cylinder is in RUN position when park lock cable is removed from

1996 Buick Riviera

STEERING COLUMN 1996 STEERING General Motors Corp. - Steering Column

Virtual Wrench

2005 Mitchell Repair Information Company, LLC.