Продукция бренда Buick

Removal & Installation (Floor Shift)

Disconnect negative battery cable. Remove shift lever handle. Disassemble console as necessary for access to

shift control assembly. Disconnect park lock cable, shift control cable and electrical connectors. Remove shift

control assembly. Remove interlock solenoid. To install, reverse removal procedure. Tighten shift control

assembly mounting nuts to 18 ft. lbs. (24 N.m).

PIVOT & PULSE SWITCH

Removal & Installation

Disconnect negative battery cable. Remove upper cover. See UPPER & LOWER COVER

. Remove tie wraps

and wire harness strap. Disconnect electrical connector. Remove mounting screws. Remove pivot and pulse

switch assembly. To install, reverse removal procedure. Tighten mounting screws to 46 INCH lbs. (5.2 N.m).

SIR COIL ASSEMBLY

Removal & Installation

Turn wheels to straight ahead position. Turn ignition switch to OFF-LOCK position. Remove steering wheel.

See STEERING WHEEL. Remove upper cover. See UPPER & LOWER COVER . Remove SIR coil

retaining ring. Remove wire restraint clip, tie wrap and wire harness strap. Remove SIR coil assembly. To

install, reverse removal procedure. Ensure wheels and SIR coil assembly are centered.

TURN SIGNAL & COMBINATION SWITCH

Removal & Installation

1. Remove steering wheel. See STEERING WHEEL. Remove upper and lower cover. See UPPER &

LOWER COVER

. Disconnect steering column electrical connector. Remove tie wraps and wire harness

strap securing turn signal and combination switch harness. On column shift, disconnect interlock solenoid

electrical connector.

2. On floor shift, disconnect pivot and pulse switch electrical connector. On all models, remove Gray and

Black turn signal and combination switch connectors from column connector. Remove 17-way secondary

lock from Gray connector and disconnect pass key terminals (if equipped), from cavities 16 and 17. See

Fig. 2 . Remove mounting screws and turn signal and combination switch assembly.

3. To install, compress electrical contact with small screwdriver while moving turn signal and combination

switch into position. Ensure electrical contact rests on cancelling cam. To complete installation, reverse

removal procedure. Tighten mounting screws to 46 INCH lbs. (5.2 N.m).

IGNITION & KEY ALARM SWITCH ASSEMBLY

Removal & Installation

1. Remove upper and lower cover. See UPPER & LOWER COVER . Disconnect steering column

electrical connector. Remove Gray and Black turn signal and combination switch connectors from

column connector.

1996 Buick Riviera

STEERING COLUMN 1996 STEERING General Motors Corp. - Steering Column

Virtual Wrench

2005 Mitchell Repair Information Company, LLC.