Connect Systems Inc. - Model 9800 Page 36
The 9800 will hold the auto answered call for thirty seconds giving
the mobile time to respond. To answer a call and activate the two way
capability, the mobile must send the connect code (1.4.). When the
call is completed, the mobile should send the disconnect code (1.6.).
TALK BACK PAGING: A 3-27 second (4.1.) one way voice message can be
delivered to any pager or mobile from any telephone. After the auto-
answer beep enter the appropriate selective call digits shown below:
From DTMF Telephones: After the auto-answer beep, enter the desired
selective call sequence followed by *.
For Example:
DTMF : XXXXX* (x’s any length, any sequence)
CTCSS : XX* see table 2 (line 4.3. = 1)
Two Tone : XXX* see table 3 (line 4.3. = 2)
5/6 Tone : XXX* see table 4 (line 4.3. = 3)
From Dial Pulse Phones: After the auto-answer beep, dial 0 followed
by the desired selective call sequence.
For example:
DTMF : 0XXXXX* (X’s any length, any sequence)
CTCSS : 0XX* see table 2 (line 4.3. = 1)
Two Tone : 0XXX* see table 3 (line 4.3. = 2)
5/6 Tone : 0XXX* see table 4 (line 4.3. = 3)
REMOTE BASE WITH SELECTIVE CALLING: (From DTMF phones only) Remote
Base with selective calling can be accessed by entering the connect
code (1.4.) after the auto-answer beep. You can then send any
selective call code by entering the appropriate digits followed by *.
(Remote base mode 3.9. must be set to 0 if selective calling is to be
used).
Example: You've selected *7 as your access code (1.4.) and you wish to
send the selective call code 639. After the auto answer beep enter *7
639*.
MOBILE TO MOBILE SIGNALLING: The 9800 will cross mobile DTMF to CTCSS,
Two Tone or 5/6 Tone for the purpose of "waking up" another mobile,
portable or pager. (Singalling option must be installed)
If mobile to mobile signalling has been enabled (4.2.) simply send the
same mobile selective call code that would be used from a phone.
Except that the code must end with # rather than *.
If you wish to perform mobile to mobile signalling during a phone call
you must end the selective call sequence with a *.
For example:
Patch idle; XX# for CTCSS, XXX# for 5/6 or 2 Tone.
Phone call in progress; XX* for CTCSS, XXX* for 5/6 or 2 Tone.
