Connect Systems Inc. - Model 9800 Page 34
TIMEOUT TIMER: Calls will automatically disconnect at the end of the
time you selected on line 2.7. Two quick beeps heard in succession
every two seconds during the final twenty seconds warn that time out
is imminent. The timeout timer can be reset by the mobile by pressing
*.
DISCONNECTING WHEN THROUGH: If a "0" was entered on line 1.6. simply
press # to disconnect. If a "1" was entered, press # plus the connect
digits that were selected on line 1.4.
FIVE PRESS AUTO DIAL: If a "1" was entered on line 1.7., the phone
number residing in speed dial memory location No. 1 can be
automatically dialed by pressing the mobile Mic button five times in
succession. When the call is finished, five more presses will cause
disconnect. WARNING: If you press too fast or too slow the 9800 will
not respond. The correct rate is about one press per second. This
timing is required to keep rapid mobile fading and normal on channel
Mic button pressing from falsing the patch on and/or off.
Note: Disconnecting with five presses of the Mic button operates in
the Vox and Duplex modes only.
INCOMING CALLS
RINGOUT: Lines 3.3. through 3.7. allow you to customize ringout for
your application. Ringout is how the 9800 alerts you to the presence
of an incoming call.
When a call comes in, the 9800 first checks to see if the channel is
in use (3.3.). The incoming rings are counted (3.4.) before a mobile
alert is sent. The alert can consist of a Ring Tone that sounds like a
telephone ringing or a CW ID (3.5.). You may also preface the ringout
with a sequential DTMF sequence (3.6.). The user programmable DTMF
sequence can be used to operate attention getters such as a horn
honker. The type of alert selected can be set to occur only once or on
alternate rings (3.7.) of the incoming call.
To answer your call from the mobile, simply enter your access code
(1.4.). When you complete your call, send the disconnect code (1.6).
AUTO ANSWER: The 9800 must be set to automatically answer (3.8.)
incoming calls if you wish to use the Remote Base, Select Call or Talk
Back Paging Modes.
Note: If ringout is set to occur earlier in the ring cycle (3.4)
than auto answer (3.8), it is possible to receive ordinary incoming
calls plus use the modes which require an auto answer.
