19
2.3.1 ScreenCrop Utility Control Panel
Figure 2-6 ScreenCrop Utility Control Panel
Displays all detected Avitech’s Pacific converters in the same network
mask. The status button becomes active (not grayed-out) when
Pacific C-A/C-AG/C-HSS/C-SHS is selected from the IP LIST window.
Click the IP list refresh button to update the connected Avitech
devices’ IP address in the same network mask.
Changes the IP address of selected Pacific C-A/C-AG/C-HSS/C-SHS.
C-A / C-AG / C-HSS
/ C-SHS
Displays what type of Pacific converter is currently connected.
Specify the source port of the input signal or select “Autoscan.”
Configures the specific output resolution and related frame rate.
Shows the operational status of the selected Pacific C-A/C-AG/
C-HSS/C-SHS. This button is only available (not grayed-out) when the
Pacific C-A/C-AG/C-HSS/C-SHS is selected in the “IP LIST” window
(refer to section 2.3.3 for details).
Displays and adjusts the cropped instance’s size and related location.
After entering/adjusting the Left/Top/Width/Height parameters, click this
button to change the location of the four green cropping corners.
Chooses between 2 different area of interest instances (Instance One or
Two) and then set the cropping parameters.
