PCB Assembly
To remove the PCB assembly and housing
assembly:
and Housing
Assembly
1.
Separate the paper tray assembly and the housing
assembly, and remove the frame assembly
.
2.
Remove the metal spring plate, which holds the sheet
adjuster in place, by squeezing the three tabs (Figure
5, #1) together with a pair of needlenose pliers.
3.
Disconnect the spring (Figure 5, #2) that holds the
paper stopper in place.
4.
Remove the e-ring (Figure 5, #3) from the pointed end
of the spring plate shaft.
FIGURE 5
5. Set the housing assembly on its side, squeeze the
three tabs again (Figure 5, #1), and push them
through the openings in the housing. Turn the
housing over and remove the plastic spring plate with
the attached pieces (Figure 6).
