2.
Position the lower paper tray so it is facing you. Place
the roller assembly into position (the white eject shaft
should be on the bottom). Snap the roller assembly
into position by lining up the four tabs (two on each
side) and snap it into position (Figure 9, #2 and #3).
3.
Locate the paper tray detent plate. Position the plate
on the left side (Figure 9, #4). Insert the paper tray
detent shaft.
4. Position the upper paper tray on the lower paper tray.
Be sure the two tabs located at the front slide into the
lower half (Figure 9, #5). Snap the tray into position.
5.
Reconnect the paper tray locks (Figure 9, #6).
6. Connect the paper tray assembly to the housing
assembly.
ImageWriter II rev. Aug 87 SheetFeeder / 6. 15
