To remove the paper tray assembly:
1. Separate the paper tray assembly from the housing
assembly.
2.
Position the paper tray as shown in Figure 8, the main
drawing. Pry off the paper tray locks (Figure 8, #1).
Using a small flathead screwdriver, pry off the upper
paper tray (the hinges are part of the upper paper
tray). The tray snaps onto the tabs. Some of the tabs
may break off as you remove it.
3.
Locate the paper tray detent plate on the left side
(Figure 8, #2). Remove the paper tray detent shaft. Lift
the paper tray detent plate off the lower paper tray.
Set the parts aside for later use.
4.
Gently pull the idler gear, on the left side of the tray,
toward you to release tab 1. At the same time, insert a
jeweler's screwdriver under tab 2, and slide the left
roller holder free of the tabs (Figure 8, #3).
5. Using a jeweler's screwdriver, gently pry loose tab 1
on the right side of the tray. Pry loose tab 2 and lift the
right roller holder free (Figure 8, #4).
6.
Remove the entire assembly from the lower paper
tray.
7.
Remove the roller springs (Figure 8, #3 and #4) from
both sides of the assembly. The springs hold the
roller shaft and the eject shaft in place.
8.
For later use, set aside the left and right roller holders,
and the one roller shaft still connected to the small
gear.
ImageWriter II rev. Aug 87 SheetFeeder / 6. 13
