8825/8830 Controller Setup Manual for Firmware 6.0 126

Configuring the System Administration Parameters (continued)

Setting The Job Accounting Parameters (continued)

PATH TO THE JOB ACCOUNTING PARAMETERS

At the Printer Control Panel when the display shows <IDLE>, press [ON-

LINE]. When the display shows <PAUSED>, press [ENTER]. When the

display shows <UTILITIES>, press [NEXT] until <SYSTEM

ADMINISTRATION> is displayed. Press [ENTER] and, using the numeric

keypad, input the required “password,” press [ENTER] again. If <JOB

ACCOUNTING> is not displayed, press [NEXT] until it is, then press

[ENTER]. Press [NEXT] to display your choice of “Accounting Administration,

“Printer Accounting Mode,” or “Reports.” Press [ENTER] to enter the

submenu of your choice, followed by use of the [NEXT] key to display

submenu choices. Use the [ENTER] and [NEXT] keys as required to enter

parameter setting submenus and view choices within the various submenus.

Press [ENTER] to confirm your choices and [EXIT} to escape from the

current menu. Press [ON-LINE] to place the printer back on line when done.

REFERENCE FOR ADDITIONAL INFORMATION

For complete descriptive information on all Job Accounting parameters, refer

to the Job Accounting Administrator’s Manual.