2.5 Demo mode
2.5.1 Demo program mode
Display and LEDs are activated automatically for demonstration.
Electronic components are not switched on.
To activate/deactivate the demo program mode, refer to Demo mode – activate /
deactivate, 070 4.3, Demo mode – activate / deactivate, 070 4.4.
2.5.2 Demo program mode (program simulation)
The unit can be operated.
Electronic components are not switched on.
Only the LEDs and display indicators light up as in the operating mode.
To activate/deactivate the demo program mode, refer to Demo mode – activate /
deactivate, 070 4.3, Demo mode – activate / deactivate, 070 4.4.
2.6 Fault dialogue
The power electronic (ELP) monitors the electronic sensors.
If the power electronic (ELP) registers a fault, it sends a fault message to the
control electronic (EW).
The control electronic (EW) shows the fault message in the display.
Technical faults are saved by the power electronic (ELP).
If the communication between the power electronic (ELP) and the control
electronic (EW) is defective, the EW sends the message independently that a
fault has occurred.
Descriptive Technical Documentation
070-10 DTD no. 11-4800
This information should not be duplicated or passed on without Miele approval. All rights reserved. 22.12.2006, US_am
