92
Printer Calibration - Error Messages Description and Corrective Action
Off line: Error: EXIT
Press RESET to Continue
This message indicates an error
occurred, in the ZONE 2 Exit Sensor
(EXIT), during the sensor calibration
procedure.
This error can occur when:
• Media dust or debris obstructs the
Exit Sensor.
• The Exit Sensor cable fails or is not
connected properly.
• The Exit Sensor fails.
• A component fails on the Main
Controller PCB.
To correct this error:
1. Perform the cleaning procedures and
vacuum out all media dust and debris.
2. If this error continues, power the unit
off and check internal cable
connections.
