95
Printer Calibration - Error Messages Description and Corrective Action
Off line: Error: O-FULL
Press RESET to Continue
This message indicates an error
occurred, in the Output Bin Full Sensor
(O-FULL), during the sensor calibration
procedure.
This error can occur when:
• A calibration stack of 190 coupons
was not placed in the Output Bin
prior to running the sensor calibration
test.
• Media dust or debris obstructs the
Output Bin Full Sensor.
• The Output Bin Full Sensor cable
fails or is not connected properly.
• The Output Bin Full Sensor fails.
• A component fails on the Main
Controller PCB.
To correct this error:
1. Perform the cleaning procedures and
vacuum out all media dust and debris
(especially remove all dust inside the
REJECT BIN and OUPUT BIN
sensors).
2. Place a calibration stack of 190 flat
coupons in the OUTPUT BIN and
rerun the test.
3. If this error continues, power the unit
off and check internal cable
connections.
