Produkty značky Leica-biosystems

Instructions for Use V 1.9 RevD - 05/2013

5. Operation

TRAY LOAD Controls the movement of the lifting table of the

automated unload station (optional)

Place a stack of trays (37) onto the lifting table of

the unload station (Fig. 43).

Any number of trays between 1 and 10 can be

inserted, as the printer counts the trays when

they are inserted.

Once the lifting table has reached its highest

position, the LED in the button starts blinking.

Press and hold TRAY LOAD longer than 1 sec:

• The traystackmoves completelyintothe

unload station, the LED in the button goes off,

the printer switches to ONLINE mode.

• Pendingprintjobswillbecarriedout.

When the stack of trays has moved into the

unload station completely or partly:

Press TRAY LOAD briefly

• Thestackoftraysmovesupbyonetray.

If TRAY LOAD is pressed and held longer than

one second:

• Thestackof traysmoves completelyout of

the unload station, the LED in the button starts

flashing. Any print job in progress is inter-

rupted.

If your printer is not equipped with

an automated unload station, no

function is assigned to this button!

Fig. 43

Function:

• The imprintedslides arepushedout ofthe

printer and onto the uppermost tray.

• Attherightendofthetraythereisasensor

(59), which triggers a signal when covered

(Fig. 32). The tray stack is then moved upwards

by one tray.

• Oncealltraysarefull,theinstrumentemitsan

acoustic signal (beep), the LED in the TRAY

LOAD button starts blinking, the stack of trays

can be removed.

Fig. 44

Every time the printer is switched on,

the stack of trays automatically moves

one tray up, to ensure that the new

print job is started with an empty tray.

Be careful about getting near the sen-

sor (59). Any object getting closer than

2 mm to the sensor will trigger a lifting

movement.