CLOCKSPRING/ECM HARNESS
1. SOME VEHICLES ARE PREWIRED FOR CRUISE. VERIFY ECM
POSITIONS ARE OCCUPIED. IF OCCUPIED, SKIP TO CRUISE
SWITCH INSTALLATION.
2. D
ODGE CARAVAN,JOURNEY, AND TOWN & COUNTRY
APPLICATIONS: LOCATE FOUR CONNECTOR ECM AT DRIVER
SIDE FENDER WELL BEHIND SPLASH GUARD AT FRONT
WHEEL
. DODGE NITRO AND JEEP LIBERTY APPLICATIONS:
LOCATE ECM AT PASSENGER SIDE FENDER WELL. GOTO
THIRD CONNECTOR (WHITE ON BOTTOM SIDE). FIGURE 4.
R
EMOVE TOP OF CONNECTOR. LOCATE PIN 15
VIOLET/BROWN WIRE, PIN 18 VIOLET/ORANGE WIRE,
AND PIN 34 VIOLET WIRE. FIGURE 5. IF WIRES ARE PRE-
SENT, THEN VEHICLE IS PREWIRED. SKIP TO CONTROL
SWITCH INSTALLATION. IF WIRES ARE NOT IN THE POSITIONS,
USE CLOCKSPRING/ECM HARNESS SUPPLIED IN KIT.
3. R
ELEASE SLOT CLIP TO FREE PINS IN CONNECTOR.USE
PRECISION TOOL TO BREAK PLASTIC INSERT IN OPENING OF
PIN 15, 18 AND 34 OF CONNECTOR (FIGURE 6). PUSH
OUT REMAINS ON REVERSE SIDE AS SHOWN IN
FIGURE 7.
4. I
NSERT PINK CRUISE WIRE TO PIN 18 OF ECM, VIOLET
CRUISE WIRE TO PIN 34, AND YELLOW CRUISE WIRE TO
PIN 15. ONCE PINS ARE INSERTED, RE-ASSEMBLE CONNEC-
TOR. ROUTE THE CLOCKSPRING/ECM HARNESS INSIDE
VEHICLE TO STEERING COLUMN. LOOK BELOW STEERING
COLUMN. LOCATE FAR RIGHT CLOCKSPRING CONNECTOR.
F
IGURE 8. USING CLOCKSPRING/ECM HARNESS IN KIT,
INSERT PINK CRUISE WIRE TO PIN 4, YELLOW CRUISE WIRE
TO PIN 5, AND VIOLET CRUISE WIRE TO PIN 6. FIGURE
8A
PAGE 6
CAUTION: BE SURE PLASTIC INSERT IS FULLY
REMOVED BEFORE INSERTING EACH PIN.
FIGURE 6
FIGURE 4
FIGURE 5
FIGURE 7
INSTALLATION
RIGHT
CONN
FIGURE 8
FIGURE 8A
