INSTALLATION
CONTROL SWITCH
(DODGE RAM 1500/DAKOTA NEW BODY)
1. MEASURE 3/4” DOWN FROM THE BACK SIDE TOP CORNER
AND 1/4” IN FROM THE OUTER EDGE TO CUT CLEARANCE
FOR SWITCH AT RIGHT SIDE OF STEERING COLUMN.
FIGURES 8 & 9.
2. U
SE (2) #10, T25 SCREWS PROVIDED IN HARDWARE BAG
TO MOUNT CRUISE CONTROL SWITCH. FIGURES 10 & 11
3. F
OR SWITCH WITH HARNESS CONNECTOR: REMOVE FAC-
TORY 6-PIN CONNECTOR OF VEHICLE AND EXTACT PINS 2
AND 3 (HORN). FIGURE 12. REPLACE FACTORY CONNEC-
TOR WITH ROSTRA SWITCH CONNECTOR. CONNECT REMAIN-
ING TWO WIRES FROM ROSTRA SWITCH CONNECTOR TO
WIRES THAT WERE EXTRACTED FROM FACTORY CONNECTOR
.
FOR SWITCH WITH HARNESS TERMINALS: LOCATE WHITE
6 PIN CONNECTOR INSIDE STEERING WHEEL. INSERT CRUISE
CONTROL HARNESS WIRES TO THE FOLLOWING PIN LOCA-
TIONS IN BACK-SIDE OF CONNECTOR: PINK WIRE TO PIN 4;
YELLOW WIRE TO PIN 5; VIOLET WIRE TO PIN 6.
CONNECT BLACK 3 PIN CONNECTOR OF CRUISE CONTROL
HARNESS TO CRUISE CONTROL SWITCH. FIGURE 13
FIGURE 8
FIGURE 9
FIGURE 10
FIGURE 11
FIGURE 12
FIGURE 13
3/4”
1/4”
TOP CORNER
T25 SCREW
T25 SCREW
BACK SIDE
PINK WIRE
TO PIN 4
YELLOW WIRE
TO PIN 5
VIOLET WIRE
TO PIN 6
PAGE 4
