
I wrapped the connector and spades with electrical tape, since they did not feel solidly in
place with my grinded connectors, to keep them from coming off.
Make sure there is no power going to the outlet (or disconnect the blue wire from the
harness you just plugged the spade connecter into) otherwise you could blow a fuse if you
touch the blue wire to the chassis.
Run the blue wire underneath the sound blanket, and then feed it up between the folding and
fixed sections of the rear seatback. Then fold the seat down and run the wire between the
black rubber and the angle brace. Or punch a hole in the rubber and feed the wire through
as I have done.
Run the wire along the sidewall of the trunk, tape it in place.
The last step is to connect this blue wire to the orange switched power wire of the parrot (I
believe this would be the green wire on Moto units and blue wire on Nokia - check to be
sure).