176. Use tie wraps supplied in kit to fasten
hose & wires out of harms way, and to
allow smooth bends.
177. Cut the pump-wiring loom installed
earlier in step 170 so that the black and
red wires will reach the new pump.
178. The fuel pump wiring must be hooked up
correctly to work, the red Positive wire
goes to the “+” post on the pump and
the black negative wire goes to the “-”
post on the pump. (Double-check your
installation before moving on.) *Note: Do
not over-tighten the nuts and break the
studs.
179. Locate MAF cable, pull back flex loom
approximately 8 inches. Separate the
tan & black wires from this harness.
