ITG User’s Guide
Chapter 2 Installing the ITG
This chapter gives information on how to install the ITG.
2.1
Network
Requirements
For the ITG to successfully operate in your network, your network
must
meet
the
following
requirements:
1.
A working 10/100 Base-T Ethernet. The ITG connects to Internet via an Ethernet LAN.
2.
IP
network
that supports gateway, and subnet mask. You’ll need static IP address to
assign the ITG.
2.2
Installing the ITG
Due to the ITG is used in a desktop configuration. Ensure that the ITG is placed in a clean,
well-ventilated, and vibration-free environment.
When the ITG is used, be certain that the unit is placed on a sturdy, flat surface,
near
a
grounded power outlet. At least three inches of
clearance
must
be
provided
on
both
sides
of
the ITG for good ventilation.
2.3
Connecting to the telephony devices
The ITG supports two types of TIM. One is FXO and the other is FXS. 2 ports ITG
supports
FXS only, and 4 ports ITG supports 2 FXO
and
2
FXS. Each port has RJ11 ports
for connecting to telephony devices.
The FXO module is designed for connecting to PBXs or central office switches.
The
FXS
module
is designed for connecting to analog telephone sets or G3 fax machines.
Connecting the telephony devices to the
appropriate RJ11 ports on the TIM.
Warning:
connection
of incorrect telephony devices to the ports on the TIM can cause
permanent damage to the TIM and/or the ITG
.
2.4
Connecting to the Network
The RJ45 network port on the
rear
panel
supports 10/100 Mbps half-duplex connections to
Ethernet. You can use either Category 3 or 5 straight-through UTP cable for 10 Mbps
connection, but use Category 5 for 100 Mbps connection. To connect to
Ethernet,
insert
one
end of the Ethernet cable to the
RJ45
port
on
the rear panel of the ITG and other end of the
cable to an Ethernet switching hub or repeater hub.
2.5
Providing Power to the ITG
To provide power to the ITG complete the following steps:
Overview
13
