4
[Windows 7 & Google Chrome Example]
The TP-Link has been pre-programmed from QRS so it’s not necessary to reset it. But, if the SSID name shown on the back of the TP-Link
appears in your wireless network connection list, it’s been reset.
To reset the WR702N, press and hold the “Reset” button on the side of the TP-Link for 8 seconds, or until the light blinks at lease 3 times.
Set a Static IP on your device
A Left-Click on the network signal strength indicator.
B
Connect to the WiFi SSID listed on the back of the TL-WR702N.
TP-Link_50B880 in our example.
C After you’re connected go back and select “Open Network and Sharing Center”
D Select “Change Adapter Settings”
E
Right-Click over your active “Wireless Network Connection
Select “Properties”.
F
Select “Internet Protocol Version 4 (TCP/IPv4)”
Select “Properties”.
G
Select “Use the following IP address” and enter:
IP address: 192.168.0.5
Subnet mask: 255.255.255.0
Gateway: 192.168.0.1
Press the OK button, wait a few seconds.
Close all windows.
Click “Quick Setup”
Click “Next”
Select “Router: Router Mode”
Click “Next”
Change the SSID to QRSPNO
Under “Security Options:” select “Disable Security”
Click “Next”
Under “WAN Connection Type” select “Dynamic IP”
Click “Next”
Under “MAC Clone” select “No”
Click “Next”
Connect to the QRSPNO, step “A” above.
Open your browser and navigate to 192.168.0.254
If necessary, enter “admin” as the ID and Password
Under “Advanced Settings” click DHCP
Under DHCP Server” select “Enable”
Press “Save” and “OK” and close Google Chrome.
Re-do steps A-G above.
At step “G” select “Obtain an IP address automatically”
Press “OK”
Close all windows.
On the QRS PNOmation II remote control:
Press the following buttons in sequence…
SHIFT FUNC 9 9 0
The third light should be green.
Press SHIT INFO to conrm the 192.168.1.1 address.
Open Google Chrome and navigate to 192.168.0.254
Enter “admin” as the User Name and Password.
Press the “Log In” button. You may have to wait for the TP-Link below to appear.
Click “Reboot”
Click “OK” to conrm.
The TP-Link will congure and restart.
How to Congure the TP-Link TL-WR702N to Stand Alone Mode after a TP-Link Reset:
