2
On the QRS PNOmation II remote control:
Press the following buttons in sequence…
SHIFT FUNC 9 9 1
Third light ashes red/green and then yellow.
[Windows 7 & Google Chrome Example]
Set a Static IP on your device
A Left-Click on the network signal strength indicator.
B Connect to the “QRSPNO”
C After you’re connected go back and select “Open Network and Sharing Center”
D Select “Change Adapter Settings”
E
Right-Click over your active “Wireless Network Connection
Select “Properties”.
F
Select “Internet Protocol Version 4 (TCP/IPv4)”
Select “Properties”.
G
Select “Use the following IP address” and enter:
IP address: 192.168.0.5
Subnet mask: 255.255.255.0
Gateway: 192.168.0.1
Press the OK button, wait a few seconds.
Close all windows.
Open your browser and navigate to 192.168.0.254
Enter “admin” as the User Name and Password.
Press the “Log In” button.
Click “Quick Setup”
Click “Next”
Select “Bridge Mode”
Click “Next”
Click the “Survey” button.
Click “Connect” for the SSID of the network you wish to join
Change the SSID to “QRSPNO Network”
Under “Security Options” choose the type of security (WEP or WPA)
Enter your network password in the “PassWord” box
Click “Next”
If prompted, change the channel setting displayed.
Press “OK” and then do so and click “Next”
Select “Disable Security” (Unless you want to secure the network)
Click “Next”
Click “Reboot”
Click “OK” to conrm.
Restarting
Close browser
Re-do steps A-G above.
At step “G” select “Obtain an IP address automatically”
Press “OK” and close all windows.
Connect to your home network
The TP-Link is now linked to your home network and ready for “Network Mode” on the PMII.
If you did not hear the IP address press SHIFT and then INFO on the QRS remote control.
Open Safari or Google Chrome and enter the IP address heard from the speaker.
PLx light # 3 should be YELLOW.
Lighted button on the PMII processor should be FLASHING.
How to congure the TP-Link TL-WR702N from “Stand Alone” Mode to “Network Mode”:
